No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a DHCPv6 Server

Configuring a DHCPv6 Server

Pre-configuration Tasks

You can configure a DHCPv6 server to dynamically assign configuration information such as IPv6 addresses to DHCPv6 clients.

Before configuring the DHCPv6 server, complete the following tasks:

  • Ensure that the link between the DHCPv6 client and the switch works properly and the DHCPv6 client can communicate with the switch.

  • (Optional) In the scenario where the DHCPv6 relay exists, configure the route between the switch and DHCPv6 relay agent or client.

Configuration Procedure

The configuration tasks are performed in sequence.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065678

Views: 29481

Downloads: 222

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next