No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How a DHCP Client Reuses an IP Address

How a DHCP Client Reuses an IP Address

If a DHCP client reconnects to a network, it may be able to reuse the IP address that it had been previously allocated. The DHCP client exchanges DHCP messages with a DHCP server to attempt to obtain the previously used network parameters, including the IP address. Figure 3-7 shows this message exchange, which is called two-message exchange.

NOTE:

Not all clients can reuse IP addresses that have been allocated to them. The following uses a PC as the DHCP client to describe how the DHCP client reuses an IP address.

Figure 3-7  Message exchange for IP address reuse between a DHCP client and a server

Stage 1: The Request Stage

The DHCP client broadcasts a DHCP Request message that contains the IP address used previously by the client. The requested IP address is added in the Option 50 field.

Stage 2: The Acknowledgment Stage

After receiving the DHCP Request message, the DHCP server checks whether there is a lease record based on the MAC address in the message. If there is a lease record matching the MAC address, the DHCP server replies with a DHCP Ack message to notify the client that it can use the requested IP address. Otherwise, the server ignores the request and waits for a new DHCP Discover message from the client.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065678

Views: 30783

Downloads: 230

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next