No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Function of Recording a Log When an IPv6 Address or Prefix Is Allocated

(Optional) Configuring the Function of Recording a Log When an IPv6 Address or Prefix Is Allocated

Context

Recording a log on the DHCPv6 or DHCPv6 PD server when an IPv6 address or prefix is allocated, renewed, or released, or an IPv6 address or prefix conflict is detected facilitates routine maintenance and fault locating.

NOTE:

After the log recording function is enabled, the server may frequently record logs if a large number of clients request for IPv6 addresses or prefixes, deteriorating device performance.

Procedure

  1. Run the system-view command to enter the system view.
  2. Run the dhcpv6 pool pool-name command to create an IPv6 address pool and enter the IPv6 address pool view.

    By default, no IPv6 address pool is created on a device.

  3. Run the logging [ allocation-address-success | allocation-prefix-success | detect-address-conflict | release-address-success | release-prefix-success | renew-address-success | renew-prefix-success ] * command to enable the function of recording a log when the DHCPv6 or DHCPv6 PD server allocates an IPv6 address or prefix.

    By default, the function of recording a log when the DHCPv6 or DHCPv6 PD server allocates an IPv6 address or prefix is disabled.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065678

Views: 24907

Downloads: 163

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next