No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring IPv6 Running Status

Monitoring IPv6 Running Status

Context

You can run the following commands in any view to check IPv6 running status.

Procedure

  • Run the display ipv6 interface [ interface-type interface-number | brief ] command to check IPv6 information about a specified interface.
  • Run the display ipv6 statistics command to check IPv6 traffic statistics.
  • Run the display icmpv6 statistics command to check ICMPv6 traffic statistics.
  • Run the display tcp ipv6 status command to check the TCP6 connection status.
  • Run the display tcp ipv6 statistics command to check TCP6 traffic statistics.
  • Run the display udp ipv6 statistics command to check UDP6 statistics.
  • Run the display ipv6 neighbors [ ipv6-address | [ vid vid ] interface-type interface-number | vpn-instance vpn-instance-name ] command to check neighbor entries.
  • Run the display ipv6 socket [ socktype socket-type | task-id task-id socket-id socket-id ] command to check information about a specified socket.
  • Run the display ipv6 pathmtu [ vpn-instance vpn-instance-name ] { ipv6-address | all | dynamic | static } command to check PMTU entries.
  • Run the display default-parameter tcp6 command to check the default values of all configurable parameters on the TCP6 module.
  • Run the display ipv6 attack-source overlapping-fragment command to check source information about overlapping fragment attacks.
  • Run the display rawip ipv6 statistics command to check Raw IPv6 packet statistics.
  • Run the display tcp ipv6 authentication-statistics command to check authentication statistics of a specified TCP6 connection.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065678

Views: 24897

Downloads: 163

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next