No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an IPv4 Address and an IPv6 Address for Respective Interfaces

Configuring an IPv4 Address and an IPv6 Address for Respective Interfaces

Context

The device to be enabled with the dual stack must be configured with an IPv4 address on the IPv4 network-side interface and an IPv6 address on the IPv6 network-side interface.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface vlanif vlan-id

    The IPv4 network-side interface view is displayed.

  3. Run ip address ip-address { mask | mask-length }

    An IPv4 address is configured for the interface.

  4. Run quit

    Return to the system view.

  5. Run interface vlanif vlan-id

    The IPv6 network-side interface view is displayed.

  6. Run the following commands as required.

    • Run ipv6 address auto link-local

      The interface is configured to automatically generate a link-local address.

    • Run ipv6 address ipv6-address link-local

      A link-local IPv6 address is manually configured for the interface.

    • Run ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }

      A global unicast IPv6 address is configured for the interface.

    • Run ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length } eui-64

      An IPv6 address in EUI-64 format is configured for the interface.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065678

Views: 24808

Downloads: 162

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next