No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Service

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Disabling the IP Packet Checking Function

Disabling the IP Packet Checking Function


When the link type of an interface is QinQ or the VLAN mapping or VLAN stacking function is configured on the interface, the system checks IP packets so that the switch cannot transparently transmit IP error packets. To enable the switch to transparently transmit IP error packets, you can disable the IP packet checking function.

  • Only the S2720EI, S5720I-SI, S5720LI, S5720S-LI, S5720S-SI, and S5720SI support this function.

  • When the IP packet checking function is disabled, the IP subnet-based VLAN assignment, policy-based VLAN assignment, and IPv6 over IPv4 tunnel functions do not take effect. Therefore, confirm your action before disabling this function.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run ip error-packet-check disable

    The IP packet checking function is disabled.

    By default, the IP packet checking function is enabled.

Updated: 2019-04-20

Document ID: EDOC1100065678

Views: 30530

Downloads: 228

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next