No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Configuring UDP Helper

Example for Configuring UDP Helper

Networking Requirements

As shown in Figure 8-2, the IP address of VLANIF 100 on the Switch is 10.110.1.1/16, and the IP address of the NetBIOS-NS server is 10.2.1.1/16. The Switch and NetBIOS-NS server are on different network segments, and a reachable route exists between them. The PCs need to access each other using host names.

Figure 8-2  UDP helper network

Configuration Roadmap

The configuration roadmap is as follows:

Relay the UDP packets with destination port 137 and destination address 255.255.255.255 and the UDP packets with destination address 10.110.255.255 to the specified NetBIOS-NS server.

When the Switch receives a broadcast NetBIOS-NS Register packet, it changes the destination IP address in the IP header of the broadcast packet to the IP address of the NetBIOS-NS server and forwards the packet to the NetBIOS-NS server.

NOTE:

After UDP helper is enabled on the Switch, the Switch relays the broadcast packets with UDP destination port 137 by default. The UDP port number, therefore, does not need to be configured in this example.

Procedure

  1. Enable UDP helper.

    <HUAWEI> system-view
    [HUAWEI] sysname Switch
    [Switch] udp-helper enable

  2. Configure a destination server.

    [Switch] vlan 100
    [Switch-vlan100] quit
    [Switch] interface vlanif 100
    [Switch-Vlanif100] ip address 10.110.1.1 16
    [Switch-Vlanif100] udp-helper server 10.2.1.1
    [Switch-Vlanif100] quit
    [Switch] quit
    

  3. Verify the configuration.

    The destination server configured on VLANIF 100 is the NetBIOS-NS server.

    <Switch> display udp-helper server interface vlanif 100
    vlan-interface        Server-Ip        packet-num
    Vlanif100               10.2.1.1                0
    

Configuration Files

Switch configuration file

#
sysname Switch
#
vlan batch 100
#
udp-helper enable
#
interface Vlanif100
 ip address 10.110.1.1 255.255.0.0
 udp-helper server 10.2.1.1
#
return
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065678

Views: 34672

Downloads: 253

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next