No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing IP Performance Statistics

Clearing IP Performance Statistics

Context

The IP/TCP/UDP traffic statistics cannot be restored after being cleared. Therefore, confirm your action before clearing the IP performance statistics.

Procedure

  • After you are determined to clear IP statistics, run the reset ip statistics [ interface interface-type interface-number ] command in the user view.
  • After you are determined to clear statistics in a socket monitor, run the reset ip socket monitor [ task-id task-id socket-id socket-id ] command in the user view.
  • After you are determined to clear statistics on the dual receive buffer of the socket, run the reset ip socket pktsort task-id task-id socket-id socket-id command in the user view.
  • After you are determined to clear RawIP statistics, run the reset rawip statistics command in the user view.
  • After you are determined to clear TCP statistics, run the reset tcp statistics command in the user view.
  • After you are determined to clear UDP statistics, run the reset udp statistics command in the user view.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065678

Views: 25126

Downloads: 163

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next