No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing IPv6 Statistics

Clearing IPv6 Statistics

Context

IPv6 statistics cannot be restored after being cleared. Therefore, exercise caution before clearing IPv6 statistics.

Procedure

  • Run the reset ipv6 attack-source overlapping-fragment command in the user view to clear statistics on overlapping fragment attack packets.
  • Run the reset ipv6 socket pktsort task-id task-id socket-id socket-id command in the user view to clear statistics on the dual receive buffer of an IPv6 socket.
  • Run the reset rawip ipv6 statistics command in the user view to clear all Raw IPv6 packet statistics.
  • Run the reset tcp ipv6 authentication-statistics src-ip src-ip src-port src-port dest-ip dest-ip dest-port dest-port command in the user view to clear authentication statistics of a specified TCP6 connection.
  • Run the reset ipv6 statistics command in the user view to clear IPv6 traffic statistics.
  • Run the reset tcp ipv6 statistics command in the user view to clear TCP6 statistics.
  • Run the reset udp ipv6 statistics command in the user view to clear UDP6 statistics.
  • Run the reset ipv6 pathmtu [ vpn-instance vpn-instance-name ] { all | dynamic | static } command in the user view to clear PMTU entries.
  • Run the reset ipv6 neighbors { all | dynamic | static | vid vlan-id [ interface-type interface-number] | interface-type interface-number [ dynamic | static ] } command in the user view to clear IPv6 neighbor entries.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065678

Views: 25033

Downloads: 163

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next