No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, NETCONF, ECA, Intelligent Video O&M, eMDI, and Network Deception.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
LSP Jitter Test

LSP Jitter Test

The NQA LSP jitter test measures the jitter, delay, and packet loss ratio on LDP LSPs or TE LSPs based on the timestamps in test packets.

The LSP jitter test process is as follows:

  1. The source constructs a UDP MPLS Echo Request packet whose destination IP field is an IP address on the 127.0.0.0/8 block. The source then searches for the corresponding LSP and forwards the packet through the LSP in the MPLS domain at a certain interval. If a matching TE LSP is found, the packet can be sent from a tunnel interface and then forwarded along a specified CR-LSP.

  2. The destination (PE-B) monitors port 3503, adds a timestamp to each received packet, and sends an MPLS Echo Reply packet to the source.

  3. The source receives the MPLS Echo Reply packets and calculates the jitter by subtracting the interval at which consecutive packets are sent from the interval at which the destination receives them.

    The source can also calculate the maximum, minimum, and average jitter time in the transmission of packets from the source to the destination.

Figure 6-13  LSP jitter test scenario

LSP jitter test results and historical records are collected in test instances. You can run commands to view the test results and historical records.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065680

Views: 53243

Downloads: 504

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next