No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, NETCONF, ECA, Intelligent Video O&M, eMDI, and Network Deception.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring NetStream Aggregation Flow Statistics Exporting

Configuring NetStream Aggregation Flow Statistics Exporting


The device with NetStream aggregation flow statistics enabled can classify and aggregate original flows according to certain rules, and export the aged flows to the NSC. Aggregation of original flows will decrease network bandwidth, CPU usage, and memory space occupation.

Aggregation flow statistics can be exported only after you have specified the source IP address, destination IP address and destination UDP port number for the exported packets.


  1. Run the system-view command to enter the system view.
  2. Run the ip netstream aggregation { as | as-tos | destination-prefix | destination-prefix-tos | prefix | prefix-tos | protocol-port | protocol-port-tos | source-prefix | source-prefix-tos } command to configure a NetStream aggregation method and enter the NetStream aggregation view.
  3. (Optional) Run the mask { destination | source } minimum mask-length command to configure an aggregation mask.

    The configured aggregation mask is valid for six aggregation modes: prefix, prefix-tos, destination-prefix, destination-prefix-tos, source-prefix, and source-prefix-tos, in which:

    • The parameter source is used in prefix, prefix-tos, source-prefix, and source-prefix-tos aggregation method.
    • The parameter destination is used in prefix, prefix-tos, destination-prefix, and destination-prefix-tos aggregation method.

  4. Run the ip netstream export source ip-address command to configure the source address of the exported packets carrying flow statistics.
  5. Run the ip netstream export host ip-address port-number command to configure the destination NSC for exporting packets carrying aggregation flow statistics.

    The destination NSC address of the statistics can be configured in either the system view or the NetStream aggregation view. The destination NSC address configured in the aggregation view takes precedence over that configured in the system view. After the destination NSC address is configured:

    • Original flow statistics are exported only to the destination NSC address configured in the system view.
    • Aggregation flows are exported to the destination NSC address configured in the corresponding aggregation view. If no destination NSC address is configured in the aggregation view, aggregation flows are exported to the destination NSC address configured in the system view.

  6. Run the enable command to enable the NetStream aggregation function.

    By default, the aggregation function is disabled.

Updated: 2019-04-20

Document ID: EDOC1100065680

Views: 52482

Downloads: 500

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next