No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, NETCONF, ECA, Intelligent Video O&M, eMDI, and Network Deception.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for sFlow

Application Scenarios for sFlow

In order to prevent and limit traffic and service interruptions, as well as locate the source of potential attack traffic, enterprises need to monitor traffic statistics in real time. sFlow collects traffic, forwarding, and device status information to allow for real-time network monitoring and fault location on enterprise networks.

As shown in Figure 11-2, after sFlow configurations are performed on an sFlow agent. The agent is connected to an sFlow collector so that traffic statistics can be collected and analyzed based on interfaces.

Figure 11-2  Networking diagram for sFlow application
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065680

Views: 57191

Downloads: 514

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next