No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, NETCONF, ECA, Intelligent Video O&M, eMDI, and Network Deception.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Traffic Mirroring

Traffic Mirroring

Implementation

Traffic mirroring copies traffic matching specified rules from one or more mirrored ports to one or more observing ports, which then send the traffic to monitoring devices for analysis. Figure 8-6 shows the process of traffic mirroring. The mirrored port copies service flow 2 that matches rules to the observing port, which then forwards the copied flow to the monitoring device.

Similar to port mirroring, traffic mirroring is classified into local traffic mirroring and Layer 2 remote traffic mirroring depending on the observing port type.

Figure 8-6  Traffic mirroring

Traffic Mirroring Rules

A traffic policy containing a traffic mirroring behavior can be applied globally, in a VLAN, or on a mirrored port. Traffic mirroring rules can be configured using Modular QoS Command-Line Interface (MQC) and ACL.
  • Using MQC: It is complex to configure but supports more matching rules than ACL. MQC-based traffic mirroring can be applied to both inbound and outbound directions.
  • Using ACL: It is easy to configure but supports fewer matching rules than MQC. ACL-based traffic mirroring can only be applied to the inbound direction.

For details about traffic policies, see MQC Configuration and ACL-based Simplified Traffic Policy Configuration in the S2720, S5700, and S6720 V200R013C00 Configuration Guide - QoS.

In Layer 2 remote traffic mirroring, if a traffic policy containing traffic mirroring is applied in a VLAN, the VLAN cannot be the Layer 2 remote mirroring VLAN used on the intermediate Layer 2 network to forward mirrored packets.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065680

Views: 59317

Downloads: 516

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next