No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, NETCONF, ECA, Intelligent Video O&M, eMDI, and Network Deception.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
NMS Failed to Receive Traps

NMS Failed to Receive Traps

Fault Description

On a device running SNMPv3 to communicate with the NMS, when you run the display trapbuffer command, you can see there are trap records in the trap buffer of the information center; however, the NMS cannot receive the traps from the device.

Fault Analysis

The device runs SNMPv3 to communicate with the NMS, but the trap message version is not specified on the trap destination. By default, the device sends traps in SNMPv1 version. Because the SNMP version set on the device is different from the SNMP version of trap messages sent by the device, the SNMP module on the device does not send trap messages. Despite not being sent, the generated trap messages are still stored in the trap buffer of the information center.

Procedure

  1. Check the SNMP version running on the device.

    Run the display snmp-agent sys-info command to view the SNMP information, including system maintenance information, physical locations of devices, and SNMP version.

  2. Check the version of trap messages to be sent.

    Run the display snmp-agent target-host command to view target host information, such as target host IP address, VPN instance name, trap sending mode, secure character for sending traps, protocol version, and security level.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065680

Views: 52073

Downloads: 496

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next