No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, NETCONF, ECA, Intelligent Video O&M, eMDI, and Network Deception.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling NetStream Flexible Flow Statistics Collection on an Interface

Enabling NetStream Flexible Flow Statistics Collection on an Interface

Context

When configuring flexible NetStream, you must enable flow statistics collection and apply a flexible flow statistics template on an interface to ensure that statistics are exported successfully.

Procedure

  1. Run the system-view command to enter the system view.
  2. Run the interface interface-type interface-number command to enter the interface view.
  3. Run the port ip netstream record record-name [ inbound | outbound ] command to apply the flexible flow statistics template to the interface.

    NOTE:
    • If the vlan parameter is configured in the flexible flow statistics template, it is recommended that the template be applied to Layer 2 Ethernet interfaces.
    • If the input parameter is configured in the flexible flow statistics template, the template can be applied only to the inbound direction of an interface. If the output parameter is configured in the flexible flow statistics template, the template can be applied only to the outbound direction of an interface.

  4. Enable flow statistics collection function on an interface.
    1. Run the ip netstream { inbound | outbound } command to enable the NetStream function on the interface to collect statistics about IPv4 flows.
    2. Run the ipv6 netstream { inbound | outbound } command to enable the NetStream function on the interface to collect statistics about IPv6 flows.

      By default, IPv4 and IPv6 flow statistics are not collected.

      NOTE:
      • When the IPv4 and IPv6 flow statistics collection function is enabled on the interface, statistics about unicast and multicast packets are collected.
      • After the statistics collection function is enabled for IPv4 and IPv6 flows, the statistics are independent of each other.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065680

Views: 58090

Downloads: 514

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next