No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, NETCONF, ECA, Intelligent Video O&M, eMDI, and Network Deception.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
PWE3 Trace Test

PWE3 Trace Test

The NQA PWE3 trace test detects the MPLS-based PW path and collects statistics about each device along the path.

The PWE3 trace test process is as follows:

  1. The source constructs an MPLS Echo Request packet with the TTL set to 1 and sends it through a specified PW. When the first-hop device receives the packet, its TTL decreases to 0 and it times out. The first-hop device then returns an MPLS Echo Reply packet.

  2. Upon receiving the MPLS Echo Reply packet from the first-hop device, the source constructs an MPLS Echo Request packet with the TTL set to 2 and sends it through the PW. When the second-hop device receives the packet, its TTL decreases to 0 and it times out. The second-hop device then returns an MPLS Echo Reply packet.

  3. The source continues to send MPLS Echo Request packets, with the TTL increasing by 1 each time. This process is repeated until the source has collected information about every device on the PW.

    The source obtains the PW path from the source to the destination from the MPLS Echo Reply packets received from each hop. It also collects statistics about each device along the path.

Figure 6-17  Network for PWE3 trace test

PWE3 trace test results and historical records are collected in test instances. You can run commands to view the test results and historical records.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065680

Views: 58084

Downloads: 514

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next