No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, NETCONF, ECA, Intelligent Video O&M, eMDI, and Network Deception.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Versions for Exported Packets

Configuring Versions for Exported Packets

Procedure

  1. Run the system-view command to enter the system view.
  2. For IPv4 flexible flow statistics:
    1. Run the ip netstream export version 9 [ origin-as | peer-as ] [ bgp-nexthop ] command to set the version and AS option of the exported packets carrying IPv4 flexible flow statistics.

      By default, V9 supports the exported packets carrying IPv4 flexible flow statistics without the AS option and cannot be changed. V9 packets do not carry BGP next hop information.

      NOTE:

      After a NetStream server restarts, you can run the refresh netstream template command in the user view to enable the switch to resend NetStream export template.

    2. (Optional) Run the ip netstream export template timeout-rate timeout-interval command to configure the interval at which the switch sends the NetStream export template to the NetStream server when IPv4 flexible flow statistics is exported in NetStream V9.

      By default, the switch sends the NetStream export template to the NetStream server at the interval of 30 minutes.

  3. For IPv6 flexible flow statistics:
    1. Run the ipv6 netstream export version 9 [ origin-as | peer-as ] command to set the version and AS option of the exported packets carrying IPv6 flexible flow statistics.

      By default, V9 supports the exported packets carrying IPv6 original flow statistics without the AS option and cannot be changed.

      NOTE:

      After a NetStream server restarts, you can run the refresh netstream template command in the user view to enable the switch to resend NetStream export template.

    2. (Optional) Run the ipv6 netstream export template timeout-rate timeout-interval command to configure the interval at which the switch sends the NetStream export template to the NetStream server when IPv6 flexible flow statistics is exported in NetStream V9.

      By default, the switch sends the NetStream export template to the NetStream server at the interval of 30 minutes.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065680

Views: 51578

Downloads: 495

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next