No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, NETCONF, ECA, Intelligent Video O&M, eMDI, and Network Deception.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Flexible Flow Statistics Template

Configuring a Flexible Flow Statistics Template

Context

You need to configure a flexible flow statistics template and aggregation keywords before applying the template to an interface. To obtain more detailed flow statistics, you can configure whether the flexible flow statistics exported to the NSC contain the number of packets and bytes, indexes of the inbound and outbound interfaces, and TCP flags of a flow.

Procedure

  1. Run the system-view command to enter the system view.
  2. Run the ip netstream record record-name command to create flexible flow statistics template and enter the flexible flow statistics template view.
  3. Run the following commands to configure aggregation keywords for flexible flow statistics:

    • match ip { protocol | dscp | source-address | destination-address | source-port | destination-port | flow-label | ttl }
    • match { vlan | source-mac | destination-mac } { input | output }

  4. (Optional) Run the collect counter { bytes | packets } command to add the number of packets and bytes to the flexible flow statistics exported to the NSC.

    By default, the flexible flow statistics that are exported to the NSC do not contain the number of packets or bytes.

  5. (Optional) Run the collect interface { input | output } command to add the indexes of the inbound and outbound interfaces to the flexible flow statistics exported to the NSC.

    By default, the flexible flow statistics exported to the NSC do not contain the index of the inbound or outbound interface.

  6. (Optional) Run the collect ip tcp-flag command to add the TCP flags of a flow to the flexible flow statistics exported to the NSC.

    By default, the flexible flow statistics exported to the NSC do not contain the TCP flags of a flow.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065680

Views: 51027

Downloads: 485

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next