No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, NETCONF, ECA, Intelligent Video O&M, eMDI, and Network Deception.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Versions for Exported Packets

Configuring Versions for Exported Packets

Procedure

  1. Run the system-view command to enter the system view.
  2. Run the ip netstream aggregation { as | as-tos | destination-prefix | destination-prefix-tos | prefix | prefix-tos | protocol-port | protocol-port-tos | source-prefix | source-prefix-tos } command to enter the NetStream aggregation view.
  3. Run the export version version command to set the version of the exported packets.

    By default, the version of the exported packets carrying IPv4 aggregation flow statistics is V8.

    NOTE:

    After a NetStream server with V9 configured restarts, you can run the refresh netstream template command in the user view to enable the device to resend NetStream export template.

  4. (Optional) Run the template timeout-rate timeout-interval command to configure the interval at which the switch sends the NetStream export template to the NetStream server when IPv4 aggregation flow statistics is exported in NetStream V9.

    By default, the switch sends the NetStream export template to the NetStream server at the interval of 30 minutes.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065680

Views: 51478

Downloads: 491

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next