No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, NETCONF, ECA, Intelligent Video O&M, eMDI, and Network Deception.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview of TWAMP Light

Overview of TWAMP Light


Two-Way Active Measurement Protocol (TWAMP) Light uses a simple structure of TWAMP. Compared with the standard TWAMP structure, TWAMP Light simplifies the control protocol used to establish the performance measurement sessions. It can flexibly collect network performance indicators (delay, jitter, and packet loss ratio), and is easy to deploy.


Traditional IP networks lack an effective, simple, and universal OAM performance measurement tool. Many vendors use proprietary features to measure IP network performance, for example, Network Quality Analysis (NQA) and IP Flow Performance Monitoring (IP FPM). However, NQA is not universally supported by devices and is difficult to deploy. IP FPM has high requirements on network devices and is difficult to deploy, so it is applicable to limited scenarios. The IETF IP performance monitoring (IPPM) team proposed a series of protocols to address the issues in IP network performance measurement. TWAMP is one of the OAM performance measurement tools applied to IP networks.


Table 12-1  Comparison of TWAMP Light and other measurement technologies



Advantage of TWAMP Light

Standard TWAMP

The Reflector must have a control plane.

The control plane is provided by the Sender, simplifying deployment.


  • Monitor the performance of multiple protocols and the packet format differs according to protocol type.
  • Deployment is complex.
  • Uniform measurement model
  • Uniform packet format
  • Simplified deployment


Clock synchronization is required.

Clock synchronization is not required and deployment is simple.

Updated: 2019-04-20

Document ID: EDOC1100065680

Views: 51442

Downloads: 491

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next