No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, NETCONF, ECA, Intelligent Video O&M, eMDI, and Network Deception.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
LLDP Networking

LLDP Networking

LLDP has the following networking modes:

  • Single-neighbor networking

    In this networking mode, interfaces between two switches or interfaces between a switch and a media endpoint (ME) are directly connected, and each interface has only one neighbor. As shown in Figure 3-5, SwitchA is directly connected to SwitchB and ME, and each interface on the switches has only one neighbor.

    Figure 3-5  Single-neighbor networking

  • Multi-neighbor networking

    In this networking mode, interfaces between three switches are not directly connected, and each interface has more than one neighbor. As shown in Figure 3-6, SwitchA, SwitchB, and SwitchC are connected through the Switch that supports LLDP transparent transmission, and each interface has more than one neighbor.

    Figure 3-6  Multi-neighbor networking

  • Link aggregation networking

    In this networking mode, interfaces between two switches are directly connected and bundled into a link aggregation group, and each interface in a link aggregation group has only one neighbor. As shown in Figure 3-7, the interfaces between SwitchA and SwitchB are bundled into a link aggregation group, and each interface has only one neighbor.

    Figure 3-7  Link aggregation networking

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065680

Views: 50995

Downloads: 485

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next