No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, NETCONF, ECA, Intelligent Video O&M, eMDI, and Network Deception.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring NetStream Flexible Flow Statistics Exporting

Configuring NetStream Flexible Flow Statistics Exporting

Context

Flexible flow statistics can be exported only after you have specified the source IP address, destination IP address and destination UDP port number for the exported packets.

Procedure

  1. Run the system-view command to enter the system view.
  2. Configure a source IP address of the exported packets carrying NetStream flexible flow statistics.
    1. Run the ip netstream export source ip-address command to configure the source address of the exported packets carrying IPv4 flow statistics.
    2. Run the ipv6 netstream export source ip-address command to configure the source address of the exported packets carrying IPv6 flow statistics.
  3. Configure a destination NSC for exporting flow statistics.
    1. Run the ip netstream export host ip-address port-number command to configure the destination NSC for exporting packets carrying IPv4 flexible flow statistics.
    2. Run the ipv6 netstream export host ip-address port-number command to configure the destination NSC for exporting packets carrying IPv6 flexible flow statistics.

    You can configure two destination IP addresses to implement NSC backup. To configure a third destination IP address, run the undo ip netstream export host or undo ipv6 netstream export host command to delete an existing one first; otherwise, the system displays a message indicating that the maximum number of IP addresses is exceeded and the configuration fails.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065680

Views: 51200

Downloads: 485

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next