No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Network Management and Monitoring, including SNMP, RMON, RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, NETCONF, ECA, Intelligent Video O&M, eMDI, and Network Deception.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Trap Function

Configuring the Trap Function

Context

A device generates traps no matter whether an NQA test succeeds or fails. NQA supports three types of traps as defined in DISMAN-PING-MIB. NQA also supports the sending of traps to the NMS when the two-way transmission delay exceeds the threshold.

  • For all test instances, if the two-way transmission delay exceeds the threshold and the trap function is enabled, traps are sent to the NMS with the specified IP address.

Traps carry the following information: destination IP addresses, operating status, destination IP address of the test packet, minimum RTT, maximum RTT, total RTT, number of sent probe packets, number of received packets, RTT square sum, and time of the latest successful probe.

Pre-configuration Tasks

Before configuring the trap function of the NQA test, complete the following tasks:

  • Configure reachable routes between the NQA client and the NMS.
  • Create the NQA test instance and configure related parameters.

Configuration Procedure

The following optional configuration tasks are performed on the NQA client.

These configurations take effect only after the NQA alarm function is enabled.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065680

Views: 58212

Downloads: 514

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next