No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
What Are the Functions and Typical Scenarios of BFD and Interface Status Association?

What Are the Functions and Typical Scenarios of BFD and Interface Status Association?

Using the process-interface-status command in the BFD session view, you can enable interface status association. When the BFD session status changes, the Line protocol current state is Up (BFD Status Down) when you run the display this interface command on the interface. At the same time, the RM withdraw the host routes and network segment routes on the interface.

Application scenario: BFD for IFNET is usually applied to the scenario where a Layer 2 device exists between two routers, or there are transmission devices, or a single fiber fault occurs.

Translation
Download
Updated: 2019-04-04

Document ID: EDOC1100065682

Views: 30048

Downloads: 253

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next