No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating a VRRP Group

Creating a VRRP Group

Context

VRRP virtualizes multiple devices into a virtual router without changing the networking, and uses the virtual router's IP address as the default gateway address to implement next-hop gateway backup. After a VRRP group is configured, traffic is forwarded through the master. If the master fails, a new master is selected from the backups to forward traffic. This implements gateway backup.

If load balancing is required in addition to gateway backup, configure two or more VRRP groups on an interface in multi-gateway load balancing mode.

Procedure

  • Create a VRRP group working in active/standby mode.

    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

      NOTE:
      You are advised not to configure a VRRP group on the VLANIF interface corresponding to a super-VLAN. If VRRP groups are configured on the VLANIF interface corresponding to a super-VLAN, the maximum number of VLANs including common VLANs, super-VLANs, and sub-VLANs is as follows:
      • S5720EI, S6720EI, and S6720S-EI: 500

      • S5720I-SI, S5720S-SI, S5720SI, S5730S-EI, S5730SI, S6720S-SI, and S6720SI: 312

      If the maximum value is exceeded, device performance may be affected.

    3. (Optional) On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

      NOTE:

      Only the S5720EI, S5720HI, S5730HI, S6720EI, S6720HI, and S6720S-EI support switching between Layer 2 and Layer 3 modes.

    4. Run vrrp vrid virtual-router-id virtual-ip virtual-address

      A VRRP group is created, and a virtual IP address is assigned to the VRRP group.

      By default, no VRRP group is created.

      NOTE:
      • If many VRRP groups are configured, increase the CPCAR of VRRP Advertisement packets. Improper CPCAR settings will affect services on your network. If you need to adjust CPCAR settings, contact technical support personnel for help.

        You can also configure an mVRRP group and bind VRRP groups to the mVRRP group to reduce CPU and bandwidth resources consumed by protocol packets.
  • Create VRRP groups working in multi-gateway load balancing mode.

    If VRRP groups need to work in multi-gateway load balancing mode, repeat the steps to configure multiple VRRP groups on the interface and assign different VRIDs to them.

Translation
Download
Updated: 2019-04-04

Document ID: EDOC1100065682

Views: 27903

Downloads: 246

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next