No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static BFD with Automatically Negotiated Discriminators

Configuring Static BFD with Automatically Negotiated Discriminators

Pre-configuration Tasks

When the remote device uses dynamic BFD and the local device wants to communicate with the remote device and detect static routes, you can create a BFD session with automatically negotiated discriminators. This function applies to networks that use static routes to implement Layer 3 connectivity.

Before configuring a BFD session with automatically negotiated discriminators, configure an IP address for the Layer 3 interface.

Configuration Process

Figure 2-17  Configuring static BFD with automatically negotiated discriminators

Context

The local device where a BFD session with automatically negotiated parameters is configured can negotiate with the remote device where a dynamic BFD session is configured; however, the local device enabled with static BFD can establish a BFD session with the remote device enabled with static BFD only. When configuring a BFD session with automatically negotiated parameters or a static BFD session, you can specify the BFD session name. The name of a dynamic BFD session is generated dynamically. When the network changes, the name of the dynamic BFD session may change.

When the remote end is configured with dynamic BFD and the local end needs to be configured with association between BFD and static route (BFD session name needs to be specified during association configuration), a BFD session with automatically negotiated parameters can be configured on the local end. Then the local end can establish a BFD session with the remote end enabled with dynamic BFD and association between BFD and static route can be implemented.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bfd

    BFD is enabled globally and the BFD view is displayed.

    By default, BFD is disabled globally.

  3. Run quit

    Return to the system view.

  4. Run any of the following commands based on the link type.

    • IPv4 links:

      Run bfd session-name bind peer-ip ip-address [ vpn-instance vpn-name ] [ interface interface-type interface-number ] source-ip ip-address auto

      A static BFD session with automatically negotiated discriminators is set up.

      By default, no BFD session is created.

    • IPv6 links:

      Run bfd session-name bind peer-ipv6 ipv6-address [ vpn-instance vpn-instance-name ] [ interface interface-type interface-number ] source-ipv6 ipv6-address auto

      A static BFD6 session with automatically negotiated discriminators is set up.

      By default, no BFD6 session is created.

    NOTE:

    You must specify the peer IP address, which cannot be a multicast IP address.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-04

Document ID: EDOC1100065682

Views: 26964

Downloads: 235

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next