No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Reliability

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of EFM Configuration Tasks

Summary of EFM Configuration Tasks

After basic EFM functions are configured, EFM can work properly. To deploy special EFM functions such as link monitoring, remote loopback, remote fault indication, and EFM association, perform the configurations according to the following sections.

Table 7-8 describes the EFM configuration tasks.

Table 7-8  EFM configuration tasks




Configure basic EFM functions

Basic EFM functions are used to monitor the link.

Configuring Basic EFM Functions

Configure EFM link monitoring

After link monitoring is configured, network administrators can detect link layer faults in various environments and dynamically monitor link quality.

Configuring EFM Link Monitoring

Configure remote loopback

Remote loopback is used to test link connectivity and performance.

Configuring Remote Loopback

Configure remote fault indication

Remote fault indication is used to detect remote device faults and monitor Ethernet performance.

Configuring Remote Fault Indication

Configure EFM association

EFM can be associated with interfaces and detection protocols to quickly report link faults, ensuring service reliability.

Configuring EFM Association

Updated: 2019-04-04

Document ID: EDOC1100065682

Views: 36980

Downloads: 257

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next