No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Reliability

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of BFD Configuration Tasks

Summary of BFD Configuration Tasks

The device supports the following BFD features: BFD session setup, BFD detection mode, single-hop and multi-hop BFD, static BFD with automatically negotiated discriminators, BFD Echo function, association, and dynamic change of BFD parameters.

Table 2-5 describes the BFD configuration tasks.

Table 2-5  BFD configuration tasks




Configure single-hop BFD.

Single-hop BFD fast detects faults on the directly connected link.

Configuring Single-Hop BFD

Configure multi-hop BFD.

Multi-hop BFD fast detects faults on the indirectly connected link.

Configuring Multi-Hop BFD

Configure static BFD with automatically negotiated discriminators.

When the remote device uses dynamic BFD and the local device wants to communicate with the remote device and detect static routes, you can create a BFD session with automatically negotiated discriminators. This function is mainly used in scenarios where static routes are used to implement Layer 3 connectivity.

Configuring Static BFD with Automatically Negotiated Discriminators

Configure the BFD Echo function.

Among two directly connected devices, one device supports BFD, whereas the other device does not support BFD. he BFD Echo function is configured on the BFD-supporting device to quickly detect forwarding failures between the two devices.

Configuring the BFD Echo Function

Configure BFD association.

Association between BFD and other protocols improves upper-layer application performance and fast detects faults on links.

Configuring BFD Association

Adjust BFD parameters.

You can adjust BFD parameters so that the BFD session can fast detect faults on links.

Adjusting BFD Parameters

Updated: 2019-04-04

Document ID: EDOC1100065682

Views: 36136

Downloads: 257

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next