No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Reliability

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic Functions of Smart Link

Configuring Basic Functions of Smart Link

Pre-configuration Tasks

Basic functions of Smart Link can be configured to implement active/standby link redundancy and switching, improving network reliability. Before configuring basic functions of Smart Link, complete the following tasks:

  • Establish a dual-uplink physical network.
  • Connect interfaces and set physical parameters of the interfaces to make the interfaces physically Up.

Configuration Procedure

Perform the following configuration tasks in the listed order.

Updated: 2019-04-04

Document ID: EDOC1100065682

Views: 27293

Downloads: 240

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next