No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Enabling Revertive Switching

(Optional) Enabling Revertive Switching

Context

When the active link in a Smart Link group fails, traffic is automatically switched to the standby link. After the fault is rectified, the original active link remains blocked to ensure stable traffic transmission. To enable the original active link to transmit traffic, use either of the following methods:

  • Enable revertive switching in the Smart Link group. Service traffic will be switched to the original active link when the WTR timer expires.
  • Run the smart-link manual switch command to forcibly trigger link switching.
NOTE:

Service traffic can be switched between links in a Smart Link group only when both member interfaces are in Up state.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run smart-link group group-id

    The Smart Link group view is displayed.

  3. Run restore enable

    Revertive switching is enabled for the Smart Link group.

    By default, revertive switching is disabled in a Smart Link group.

  4. Run timer wtr wtr-time

    The WTR time is set.

    By default, the WTR time of a Smart Link group is 60 seconds.

Translation
Download
Updated: 2019-04-04

Document ID: EDOC1100065682

Views: 27301

Downloads: 240

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next