No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Reliability

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).


Generally, the Intermediate System to Intermediate System (IS-IS) sends Hello packets at an interval of 10s. The holdtime of neighbors is three times the interval that Hello packets are sent. If the Switch does not receive a Hello packet from its neighbor within the holddown time, the Switch deletes the neighbor relationship. This means that the Switch detects neighbor faults at the second level, which leads to significant packet loss on a high-speed network.

In BFD for IS-IS, BFD session establishment is triggered dynamically by IS-IS and is not configured manually. When detecting a fault, the BFD session notifies IS-IS through the RM. IS-IS will then:
  • Process the neighbor Down event.
  • Quickly update the link state PDU (LSP).
  • Perform the partial route calculation (PRC).

This speeds up IS-IS route convergence. BFD does not replace the Hello mechanism of IS-IS, but instead works with IS-IS to quickly detect link faults and to immediately notify IS-IS of route recalculation, guiding packet forwarding. Table 2-2 lists the IS-IS convergence time.

Table 2-2  IS-IS convergence time

BFD Session

Link Fault Detection Mechanism

Convergence Time

Not bound

Hello mechanism

At the second level


BFD session in Down state

At the millisecond level


Figure 2-9  BFD for IS-IS

In Figure 2-9, IS-IS is enabled on the devices and an association between BFD and IS-IS is enabled on SwitchA and SwitchB. When the link between SwitchA and SwitchB fails, BFD can quickly detect the fault and report the fault to IS-IS. IS-IS then disconnects the neighbors of this interface, which triggers topology calculation. IS-IS updates LSPs so that the neighbors, for example, Switch B's neighbor SwitchC, can receive the updated LSPs from SwitchB. This implements IS-IS fast convergence.

Updated: 2019-04-04

Document ID: EDOC1100065682

Views: 27830

Downloads: 246

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next