No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Reliability

S2720, S5700, and S6720 V200R013C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Link Auto-Recovery Mechanism

Link Auto-Recovery Mechanism

  • An interface that is manually shut down cannot automatically go Up using the link auto-recovery mechanism.

  • An interface that is automatically shut down can automatically go Up using the link auto-recovery mechanism.

    In automatic shutdown mode, DLDP sets the interface state to DLDP Down when detecting a unidirectional link. A DLDP Down interface receives and forwards only BPDUs, not user traffic. A DLDP Down interface can be recovered upon link recovery. The DLDP Down interface periodically sends RecoverProbe packets. If the interface receives correct RecoverEcho packets, the unidirectional link becomes a bidirectional link and the interface becomes Up.

    The link auto-recovery process is as follows:

    1. The DLDP Down interface sends one RecoverProbe packet every 2 seconds. A RecoverProbe packet carries only information about the local interface.

    2. Upon receiving a RecoverProbe packet, the remote end returns a RecoverEcho packet.

    3. When receiving the RecoverEcho packet, the local interface checks whether the neighbor information in the RecoverEcho packet is the same as that on the local interface. If they are the same, the link between the local interface and the neighbor has recovered. The local interface transits from Disable state to Active state and re-establishes the neighbor relationship.

Updated: 2019-04-04

Document ID: EDOC1100065682

Views: 26883

Downloads: 235

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next