Summary of CSS Configuration Tasks
CSS configuration tasks include CSS setup, CSS configuration and maintenance, and CSS split.
Table 3-2 lists the CSS configuration tasks.
| Item | Description | Task |
|---|---|---|
| Establishing a CSS | The two CSS connection modes have different hardware and software requirements. Select an appropriate mode to set up a CSS based on device resources or network requirements. To set up a CSS, confirm the software and hardware support, and complete hardware installation and software configuration. Then check whether a CSS was set up successfully. |
Use one of the following methods: NOTE:
When establishing a CSS, select either CSS connection mode as required. |
| Configuring Enhanced CSS Functions | The following configurations can be performed to enhance system reliability and facilitate CSS management:
The preceding tasks are optional and can be configured based on your needs. However, it is recommended that you configure MAD immediately after a CSS is set up. |
Configuring Enhanced CSS Functions |
| Maintaining a CSS | You can perform the following tasks during CSS maintenance:
The preceding tasks are optional and can be configured based on your needs. |
Maintaining a CSS |
| Splitting a CSS | If a CSS is not required, split the CSS to restore the member switches to standalone switches. | Splitting a CSS |
Previous
