No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S7700 and S9700 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of CSS Configuration Tasks

Summary of CSS Configuration Tasks

CSS configuration tasks include CSS setup, CSS configuration and maintenance, and CSS split.

Table 3-2 lists the CSS configuration tasks.

Table 3-2  CSS configuration tasks
Item Description Task
Establishing a CSS

The two CSS connection modes have different hardware and software requirements. Select an appropriate mode to set up a CSS based on device resources or network requirements.

To set up a CSS, confirm the software and hardware support, and complete hardware installation and software configuration. Then check whether a CSS was set up successfully.

Use one of the following methods:

NOTE:

When establishing a CSS, select either CSS connection mode as required.

Configuring Enhanced CSS Functions

The following configurations can be performed to enhance system reliability and facilitate CSS management:

The preceding tasks are optional and can be configured based on your needs. However, it is recommended that you configure MAD immediately after a CSS is set up.

Configuring Enhanced CSS Functions
Maintaining a CSS

You can perform the following tasks during CSS maintenance:

The preceding tasks are optional and can be configured based on your needs.

Maintaining a CSS
Splitting a CSS If a CSS is not required, split the CSS to restore the member switches to standalone switches. Splitting a CSS
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065738

Views: 44632

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next