Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Attributes of a Clock Source
- Preventing Timing Loops Between BITS Interfaces
- Configuring a Clock Source ID to Prevent Timing Loops
- Configuring Transmission SA Bits of the S1 Byte
- Locking a Clock Source
- Enable the Permanent Holding Mode of the Clock Module
- Configuring Frequency Offset Check
- Setting the Delay Time for the System to Consider a Clock Source Lost
- Setting the WTR Time of a Clock Source
- Configuring the Retrieving Mode of a Clock Source
- Verifying the Clock Source Attribute Configuration
Previous
