No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S7700 and S9700 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Can I Specify the Master Switch?

How Can I Specify the Master Switch?

After you connect cluster cables between two member switches to set up a CSS, set a higher CSS priority for the switch that you want to specify as the master switch and enable the CSS function on it first. This ensures that this switch is elected as the master switch.

If you want the other switch in the running CSS to be the master switch, run the slave switchover command to perform a master/standby switchover if the previous master switch has two MPUs. If the previous master switch has only one MPU, power off the switch, and power it on after the standby switch becomes the new master switch. If you specify a new master switch when the CSS is running, services will be interrupted.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065738

Views: 44085

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next