No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

S7700 and S9700 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the CSS Status

Monitoring the CSS Status


You can monitor the CSS status to locate faults.


  • Run the display css status [ saved ] command to check the CSS status.
  • Run the display css channel [ chassis chassis-id | all ] command to check CSS link connections and status.

    The chassis and all parameters are unavailable if the CSS is set up through CSS card connections.

  • Run the display css port [ port-id ] or display css port brief command to check the status and statistics about CSS ports.


    The display css port [ port-id ] command is not supported in service port clustering.

    You can monitor the packet forwarding status by collecting statistics about packets forwarded on each CSS port. If the switch collects packet statistics for a long time, much storage space will be used. In this situation, you can run the reset counters css port command in the user view to clear existing packet statistics.

  • Run the display css css-port [ saved ] [ all | chassis chassis-id ] command to verify the configuration of logical CSS ports and physical member ports when the CSS is set up through service port connections.
Updated: 2019-04-20

Document ID: EDOC1100065738

Views: 40139

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next