No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S7700 and S9700 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Optical Power Alarm Thresholds

Setting Optical Power Alarm Thresholds

Context

You can set optical power alarm so that the device generates alarms if the transmit or receive power of an optical module exceeds a threshold. An alarm may indicate that the optical module is faulty.

The default optical power alarm thresholds of an optical module are fixed and cannot be changed. These thresholds are determined through extensive testing and verification. You can configure alarm thresholds but they must be within the default range. However, this is not recommended. If an optical power alarm is generated, the first step of troubleshooting is to check the optical module and connected fibers.

NOTE:
  • You are advised to use Huawei-certified optical modules. If non-Huawei-certified optical modules are used, incorrect optical module information may be obtained during the query of optical power information.

  • Only enhanced optical modules support the query of optical power information.

  • The XGE interfaces connected to the ET1D2IPS0S00, ET1D2FW00S00, ET1D2FW00S01, and ET1D2FW00S02 cards do not support the configuration of optical power alarm thresholds.

  • The XGE interface connected to an ACU2 card does not support the configuration of optical power alarm thresholds.

Procedure

  1. (Optional) Run display transceiver [ interface interface-type interface-number | slot slot-id ] [ verbose ]

    Conventional, manufacturing, and alarm information about the optical module on a specified interface is displayed.

  2. Run system-view

    The system view is displayed.

  3. Run interface interface-type interface-number

    The interface view is displayed.

  4. Run set transceiver { transmit-power | receive-power } { upper-threshold | lower-threshold } threshold

    Upper and lower alarm thresholds are set for the transmit and receive power of the optical module on the interface. When the transmit or receive power of an optical module exceeds the upper alarm threshold or falls below the lower alarm threshold, an alarm is generated.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065738

Views: 40190

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next