No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S7700 and S9700 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Displaying the Current Configuration

Displaying the Current Configuration

Context

You can view the device configuration to learn about the services running on the device.

Procedure

  • Run the display current-configuration command to view the current device configuration.

FAQ

How Can I Determine Whether a Device Starts Using the Initial Configuration?

After a device has just started, run the display startup command to view the startup configuration file. If the startup configuration file is NULL, the device has started using the initial configuration.
NOTE:

If the device configuration has been deleted using the reset saved-configuration command after startup, it is not possible to determine whether the device has started using the initial configuration.

<HUAWEI> display startup          
MainBoard:                                                                                                                          
  Configured startup system software:        flash:/software.cc                                                    
  Startup system software:                   flash:/software.cc                                                    
  Next startup system software:              flash:/software.cc                                                    
  Startup saved-configuration file:     NULL                                                                      
  Next startup saved-configuration file:     NULL                                                                      
  Startup paf file:                          default                                                                                
  Next startup paf file:                     default                                                                                
  Startup license file:                      default                                                                                
  Next startup license file:                 default                                                                                
  Startup patch package:                     NULL                                                                                   
  Next startup patch package:                NULL     

How Can Low-Level Users View the Current Device Configuration?

The system defines a level for each command and manages commands based on command levels. The system administrator (at level 3 or higher) can run the command-privilege level level view view-name command-key command in the system view to change the command level. This configuration can enable a low-level user to use some high-level commands or raises the command level to improve device security.

Users lower than level 3 (management level) cannot run the display current-configuration command to view the current device configuration. To view the device configuration, low-level users need to apply to the administrator. The administrator then determines whether to lower the command level according to requirements.

Changing the default command level may result in operation and maintenance difficulties and bring about security risks. Therefore, it is recommended to retain the default command levels.

How Can the Current Configuration Be Displayed on Multiple Screens?

Run the screen-length screen-length [ temporary ] command in the user view or user interface view to set the number of lines displayed on a terminal screen. By default, 24 lines are displayed on a terminal screen. If screen-length is 0, the split screen function is disabled. That is, the system does not pause when the information cannot be completely displayed on one screen.

<HUAWEI> screen-length 40 temporary   //temporary is a mandatory parameter in the user view.
<HUAWEI> system-view
[HUAWEI] user-interface console 0
[HUAWEI-ui-console0] screen-length 40
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065738

Views: 45209

Downloads: 39

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next