No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S7700 and S9700 V200R013C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Alarm Reporting Delay Function

Configuring the Alarm Reporting Delay Function

Context

When an alarm is reported repeatedly, users cannot locate faults in an efficient manner. After the alarm reporting delay function is enabled and the delay is configured, a large number of repeated alarms are prevented from being reported.

After the alarm reporting delay function is enabled,

  • If no clear alarm is generated during the period, the alarm is reported to the NMS when the period expires.
  • If a clear alarm is generated during this period, the alarm and its clear alarm are both deleted from the alarm queue and will not be reported to the NMS.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run alarm

    The alarm view is displayed.

  3. Run delay-suppression enable

    The alarm reporting delay function is enabled.

    By default, the alarm reporting delay function is enabled.

  4. (Optional) Run suppression alarm-name alarm-name { cause-period cause-seconds | clear-period clear-seconds }

    The period of delay in reporting alarms is configured.

    The system has defined a default period of delay in reporting alarms.

    NOTE:
    • Run the undo suppression alarm-name and display alarm information commands in sequence to view the default period of reporting delay.

    • You can use the parameter cause-period cause-seconds to set the period after which a generated alarm is reported.

    • You can use the parameter clear-period clear-seconds to set the period after which a generated clear alarm is reported.

    • If alarm-name specifies an alarm, you can configure only cause-period cause-seconds. If it specifies a clear alarm, you can configured only clear-period clear-seconds.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065738

Views: 40232

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next