No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Interface Management

S7700 and S9700 V200R013C00

This document describes the interface management configuration, including basic interface configuration, Ethernet interface configuration, and logical interface configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Entering the Interface View

Entering the Interface View

Context

To configure an interface, enter the interface view first.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

    interface-type interface-number specifies the type and number of an interface.

    NOTE:

    If the specified interface does not exist, this command creates the interface and displays the interface view.

    • Only the E series, X series, F series, and SC series cards on the S7700 and S9700 support Ethernet sub-interface configuration. For details about the cards, see Cards in the Hardware Description.

    • Only hybrid and trunk interfaces on the preceding series of cards support Ethernet sub-interface configuration.
    • After you run the undo portswitch command to switch Layer 2 interfaces on the preceding series of cards into Layer 3 interfaces, you can configure Ethernet sub-interfaces on the interfaces.

    • The SA series cards do not support Ethernet sub-interface configuration and cannot forward IP traffic to Ethernet sub-interfaces on other cards.

    • You are advised to add a member interface to an Eth-Trunk and then configure an Eth-Trunk sub-interface. The Eth-Trunk sub-interface can be successfully configured only when the card on which the member interface locates supports Ethernet sub-interface configuration.

    • VLAN termination sub-interfaces cannot be created on a VCMP client.

Translation
Download
Updated: 2019-04-04

Document ID: EDOC1100065741

Views: 6657

Downloads: 15

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next