No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Interface Management

S7700 and S9700 V200R013C00

This document describes the interface management configuration, including basic interface configuration, Ethernet interface configuration, and logical interface configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an XGE Interface to Work in LAN/WAN Mode

Configuring an XGE Interface to Work in LAN/WAN Mode

Context

Based on the physical feature, XGE interfaces work in the following modes:
  • LAN mode: XGE interfaces working in LAN mode transmit Ethernet packets and connect to Ethernet networks. XGE interfaces working in LAN mode provide a maximum rate of 10000 Mbit/s.
  • WAN mode: XGE interfaces working in WAN mode transmit synchronous optical network (SONET)/synchronous digital hierarchy (SDH) frames and connect to upper-layer SONET/SDH networks. The upstream devices can be switches or optical network transmission devices. Interfaces working in WAN mode transmit packets at the physical layer of SONET/SDH, providing highly reliable point-to-point data connections. XGE interfaces working in WAN mode comply with OC-192/STM-64 (9553 Mbit/s) standards and use a fixed data transmission rate of 9553 Mbit/s.

As shown in Figure 2-7, XGE1/0/1 of SwitchA works in WAN mode and connects to XGE1/0/2 of SwitchB through the SONET/SDH network. XGE1/0/1 encapsulates Ethernet packets into SONET/SDH frames for transmission on the SONET/SDH network.

Figure 2-7  Networking diagram for XGE interfaces working in WAN mode

NOTE:
  • Only XGE interfaces on the ES1D2S04SX1E, ES0D0T24XA00, ES0D0S24XA00, and ES0D0X12SA00 cards of the S7700 can be switched to WAN mode. XGE interfaces on the ES0D0X12SA00 cards can be switched to WAN mode only when the transmission distance is shorter than 80 km.
  • Only XGE interfaces on the EH1D2S04SX1E, EH1D2T24XEA0, EH1D2S24XEA0, EH1D2S24XEC0, ET1D2S04SX1E, ET1D2X12SSA0, and EH1D2X12SSA0 cards of the S9700 can be switched to WAN mode. XGE interfaces on the EH1D2X12SSA0 and ET1D2X12SSA0 cards can be switched to WAN mode only when the transmission distance is shorter than 80 km.
  • When XGE interfaces on the X1E series cards work in WAN mode, the interfaces support the maximum frame length of 2560 bytes.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface xgigabitethernet interface-number

    The XGE interface view is displayed.

  3. Run set port-work-mode { lan | wan }

    The interface working mode is configured.

    By default, an XGE Ethernet interface works in LAN mode.

Translation
Download
Updated: 2019-04-04

Document ID: EDOC1100065741

Views: 6671

Downloads: 15

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next