No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Interface Management

S7700 and S9700 V200R013C00

This document describes the interface management configuration, including basic interface configuration, Ethernet interface configuration, and logical interface configuration.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring ETH Management Interface Attributes

Configuring ETH Management Interface Attributes

Context

The ETH0/0/0 management interface is a special Ethernet interface that allows users to log in to the device to perform configuration and management operations. It can be assigned an IP address. The ETH management interface does not transmit services.

For details on how to log in to the device through the management interface, see S7700 and S9700 V200R013C00 Configuration Guide - Basic Configuration.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface ethernet 0/0/0

    The ETH management interface view is displayed.

  3. Run undo negotiation auto

    The ETH management interface is configured to work in non-auto-negotiation mode.

    By default, the ETH management interface works in auto-negotiation mode.

    NOTE:

    When the management interface works in auto-negotiation mode, the rate and duplex mode cannot be configured on the interface.

    Interfaces at both ends of a link must use the same auto-negotiation mode. The interfaces cannot communicate with each other if they use different auto-negotiation modes.

  4. Run speed { 10 | 100 }

    The rate is configured for the ETH management interface.

    By default, the ETH management interface works at the maximum rate of 100 Mbit/s.

  5. Run duplex { full | half }

    The duplex mode is configured for the ETH management interface.

    By default, the ETH management interface works in full-duplex mode.

Translation
Download
Updated: 2019-04-04

Document ID: EDOC1100065741

Views: 6542

Downloads: 15

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next