No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of Multicast Network Management Configuration Tasks

Summary of Multicast Network Management Configuration Tasks

Table 16-1 lists multicast network management configuration tasks.

Table 16-1  Multicast network management configuration tasks



Configuring Basic Multicast Network Management Functions
After multicast network management is enabled, you can bind multicast MIBs to the public network instance and enable trap of a specified module. The switch then monitors events of the specified protocol. Currently, the switch supports the following multicast MIBs:
  • Internet Group Management Protocol (IGMP)
  • Multicast Listener Discovery (MLD)
  • Multicast Route Management (MRM)
  • PIM (IPv4 and IPv6)
  • Multicast Source Discovery Protocol (MSDP)
  • Layer 2 multicast
Adjusting the Frequency of Multicast Protocol Trap Messages

By setting the interval at which a multicast protocol sends trap messages, you can monitor events of the multicast protocol in a timely manner.

Configuring the Upper and Lower Alarm Thresholds for Multicast Protocol Entries

After you set thresholds for various multicast protocol entries, the switch will report a threshold crossing event when the number of multicast protocol entries reaches a specified value.

Configuring Alarm Thresholds for Multicast Index Usage

After setting the alarm threshold of the multicast index usage, you can learn the multicast index usage in a timely manner. This prevents multicast service failures caused by index resource exhaustion.

Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 47698

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next