No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Suppressing Report and Done Messages

(Optional) Suppressing Report and Done Messages

Context

The MLD protocol maintains group memberships based on periodic Query and Response messages. When multiple members join the same group, they send identical Report messages to the MLD router. When hosts leave a group, they send identical Done messages. To conserve bandwidth, configure suppression of Report and Done messages on the switch.

After MLD message suppression is configured, the switch sends a Report message only when the first member joins a multicast group and a Done message only when the last member leaves the multicast group.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    The VLAN view is displayed.

  3. Run mld-snooping report-suppress

    Report and Done message suppression is enabled.

    NOTE:

    When configuring MLD message suppression, pay attention to the following:

    • After MLD message suppression is enabled in a VLAN, IPv6 Layer 3 multicast functions (such as MLD and IPv6 PIM) cannot be enabled on the corresponding VLANIF interface.
    • MLD snooping proxy and message suppression cannot be configured in the same VLAN.
    • The switch can suppress duplicate Report messages even when MLD message suppression is disabled. The default suppression time is 10 seconds. To change the suppression time, run the mld-snooping suppression-time suppression-time command. If suppression-time is set to 0, all membership packets are forwarded immediately.
    • If multicast VLAN replication is configured, the MLD message suppression function cannot be enabled in user VLANs.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 46391

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next