No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MLD Fast Leave

Configuring MLD Fast Leave


In some scenarios, a Multicast Listener Discovery (MLD) querier interface connects to only one receiver host. If the host frequently switches between multiple multicast groups, you can configure the fast leave function on the interface so that the interface can quickly respond to Multicast Listener Done messages sent from the host.

After fast leave is configured, the querier does not send a Multicast Address Specific Query message or Multicast Address and Source Specific Query message after receiving a Multicast Listener Done message. Instead, the querier directly notifies the upstream multicast device that the host has left the multicast group. The fast leave function reduces delay in response to Done messages and saves network bandwidth.

To limit the range of multicast groups that member hosts can leave fast, configure an IPv6 access control list (ACL6) to define the range of multicast groups and then reference this ACL6. For details about the ACL6 configuration, see ACL Configuration in the S7700 and S9700 V200R013C00 Configuration Guide - Security.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run mld prompt-leave [ group-policy { acl6-number | acl6-name acl6-name } ]

    Fast leave is configured on the interface.

    By default, the switch sends Multicast Address Specific Query messages or Multicast Address and Source Specific Query messages after receiving a Done message.


    When configuring an ACL6 for an interface, use the permit parameter to allow the hosts connected to the interface to quickly leave multicast groups with addresses in a specified range. If no rule is configured in the ACL6, hosts connected to the interface cannot quickly leave any multicast groups.

Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 48514

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next