No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an RP

Configuring an RP

Context

To use the Anycast RP feature, configure multiple RPs with the same address in a PIM-SM domain. Before configuring Anycast RP in the PIM-SM domain, configure a loopback interface on each switch and assign the same IP address to the loopback interfaces. Then configure these interfaces as static RPs or candidate rendezvous points (C-RPs).

  • To use a static RP, configure the RP address on each switch in the PIM-SM domain.
  • To use a dynamic RP, C-RP address only on the switches that need to provide the Anycast RP function.
NOTE:

After an RP is configured, the RP interface address needs to be advertised using a unicast routing protocol so that each switch on the network has a reachable route to the RP interface.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface loopback interface-number

    The loopback interface view is displayed.

  3. Run ip address ip-address { mask | mask-length }

    An IP address is configured for the loopback interface.

  4. (For dynamic RP configuration) Run pim sm

    PIM-SM is enabled on the interface.

    This command is not required if you configure a static RP.

  5. Run quit

    Return to the system view.

  6. Run pim [ vpn-instance vpn-instance-name ]

    The PIM view is displayed.

  7. Configure the loopback interface address as a static RP address or C-RP address.

    • Configure a static RP.

      Run static-rp rp-address

      The loopback interface address is configured as a static RP address.

    • Configure a dynamic RP.

      NOTE:

      When configuring dynamic RP, configure candidate bootstrap routers (C-BSRs). Ensure that the C-BSR and the C-RP addresses are different. For details on how to configure a C-BSR, see Configuring a C-BSR.

      Run c-rp loopback interface-number

      The loopback interface address is configured as a C-RP address.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 48533

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next