No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Static MLD Multicast Groups on an Interface

(Optional) Configuring Static MLD Multicast Groups on an Interface

Context

You can configure static multicast groups on user-side interfaces of a switch in some scenarios, such as when:

  • Stable group members exist on the network, requiring fast and stable multicast data forwarding.

  • Hosts require multicast data but cannot send Multicast Listener Report messages.

After a static multicast group is configured on an interface, the switch considers that group members exist on the network segment of the interface and always forwards multicast data to the group.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run mld static-group ipv6-group-address [ inc-step-mask ipv6-group-mask-length number group-number ] [ source ipv6-source-address ]

    One or more static multicast groups are configured on the interface.

    By default, no static multicast group is configured on an interface.

    NOTE:

    If a static Multicast Listener Discovery (MLD) group is configured on a loopback interface, the switch forwards multicast data to this group only when users request the data, which reduces traffic on the network. If a static MLD group is configured on other MLD-capable interfaces, the switch forwards multicast data to the group immediately after receiving the data. For example, you can configure static multicast groups on a loopback interface if users may request data of these groups but have not requested the data at present. If some multicast groups have stable receivers on a network segment, you can configure the static multicast groups on the interface connected to this network segment.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 46278

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next