No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the RPF Check Policy Configuration

Verifying the RPF Check Policy Configuration

Context

After changing the reverse path forwarding (RPF) check policy, check the multicast static routing table, multicast routing table, and RPF routing table to verify that the multicast network can operate normally.

Procedure

  • Run the display multicast routing-table [ vpn-instance vpn-instance-name ] static [ config ] [ source-address { mask | mask-length } ] command to check the multicast static routing table.
  • Run either of the following commands to check the multicast routing table:

    • display multicast { vpn-instance vpn-instance-name | all-instance } routing-table [ group-address [ mask { group-mask | group-mask-length } ] | source-address [ mask { source-mask | source-mask-length } ] | incoming-interface { interface-type interface-number | register } | outgoing-interface { include | exclude | match } { interface-type interface-number | register | none } ] * [ outgoing-interface-number [ number ] ]

    • display multicast routing-table [ group-address [ mask { group-mask | group-mask-length } ] | source-address [ mask { source-mask | source-mask-length } ] | incoming-interface { interface-type interface-number | register } | outgoing-interface { include | exclude | match } { interface-type interface-number | vpn-instance vpn-instance-name | register | none } ] * [ outgoing-interface-number [ number ] ]

  • Run the display multicast [ vpn-instance vpn-instance-name | all-instance ] rpf-info source-address [ group-address ] [ rpt | spt ] command to check the RPF route to a specified multicast source.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 42069

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next