No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
An MSDP Peer Stays in Down State

An MSDP Peer Stays in Down State

Fault Description

After an MSDP peer is configured, it stays in Down state.

Fault Analysis

An MSDP peer relationship is set up based on a TCP connection between a local interface address and a remote MSDP peer.

  • If the local interface address is different from the MSDP peer address configured on a remote device, the TCP connection cannot be set up.
  • If two MSDP peers have no route to each other, the TCP connection cannot be set up.

Procedure

  1. Check whether the two MSDP peers have learned ARP entries from each other.

    Run the display arp all command to check ARP entries on the two devices.

  2. Check whether the two devices have reachable unicast routes to each other.

    Run the display ip routing-table command to check the routing table of the two devices.

  3. Check whether the interface addresses used to set up MSDP peer relationships are correct.

    Run the display current-configuration command to check whether the local interface address is the same as the remote MSDP peer address configured on the remote device.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 43348

Downloads: 40

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next